2008 Hyundai Santa Fe P0752 Fault Code Check
When you check 2008 Hyundai Santa Fe car engine light came on code P0752 the reason should be Engine Light ON (or Service Engine Soon Warning Light). However Hyundai manufacturer may have a different definition for the P0752 OBD-II Diagnostic Powertrain (P) Trouble Code. So you should chech it on our car models.
On 1999 and later P0752 2008 2008 Hyundai Santa Fe engines, the instrument cluster has a built-in self-diagnostic mode that can be accessed by pressing and holding the instrument cluster SELECT/RESET button. Insert the ignition key and turn to the RUN position (but don't crank or start engine). Continue to press and hold the SELECT/RESET button (for 5 seconds) until the word TEST is displayed by the odometer. Release the SELECT/RESET button within three seconds after the word TEST is displayed to begin the self-diagnostic mode.
2008 Hyundai Santa Fe P0752 OBD-II Diagnostic Powertrain (P) Trouble Code Description2008 Hyundai Santa Fe car P0752 OBD-II Trouble Code Shift solenoid valve A is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (Reason For 2008 Hyundai Santa Fe P0752 CodeThe reason of 2008 Hyundai Santa Fe P0752 OBD-II Fault Code Check is P0752 Shift Solenoid A Performance or Stuck On. |
|
2008 Hyundai Santa Fe P0752 Possibble Fix Ways :
A failing oil pump can cause what's called oil starvation, which is almost always fatal to any engine. Overhead cam engines are especially at risk, because the cam and valve train are farther from the pump than they are in pushrod engines. Oil should be of a proper viscosity, which means it needs to be light enough to move quickly.
If your vehicle failed a P0752 2008 2008 Hyundai Santa Fe test and the P0752 Check Engine Light is NOT on, chances are you have a problem with the OBDII system, a burned out MIL lamp, or a faulty catalytic converter. The converter is essentially an afterburner that cleans up the exhaust after it exits the engine. The OBDII system uses P0752 a ownstream oxygen sensor to monitor the efficiency of the converter, and it should detect a drop in converter efficiency if the converter has been contaminated or is failing (ignition misfiring, leaky exhaust valves, and oil burning can all damage the converter). What you want to look P0752 2008 2008 Hyundai Santa Fe: Any conditions that might cause ignition misfire, an overly rich or lean fuel condition, or loss of compression.
|
What does fault code P0752 mean for 2008 Hyundai Santa Fe ?
|